|
Are
you tired of your contractors cutting holes in
I-Joist where they do not belong? Cutting a hole to
close to bearing or into a flange is a costly
mistake and requires a fix designed by an engineer.
We
have developed the perfect solution to all of those
problems. The LRC T.E.C.H-Joist, which stands
for Trimable End Circular Hole Joist allows the
builder to field trim these joist up to a certain
point in able for the joist to fit the foundation.
Once the joists are in place the 8" hole in the
11-7/8" I-Joist allows for
mechanical contractors to run duct work, wires, and
plumbing lines with out cutting a joist, saving time
and money.
Cutting
holes in solid sawn lumber limits your hole
placement and size of the hole. Do you know
that a hole cut in a 2x12 has to be less than 4" and
cannot be within 2 inches of the top and bottom of
the member? This is not a very big hole!
With the LRC TECH-Joist we can cut twice as big a
hole without cutting into the flange. |
